AutoCAD MEP Wishes

Reply
Valued Contributor
Mark_Richards
Posts: 51
Registered: ‎10-02-2008
Message 1 of 1 (317 Views)

Multiple Branch Circuit Prompt

317 Views, 0 Replies
09-24-2009 01:59 PM
If, when wiring devices with a particular circuit, you click on a device that has already been assigned a different circuit, you are presented with a dialog box stating "create a multiple branch circuit? Yes/No?

This happens to me a lot when I copy an existing fixture to a new location but forget to clear the circuit assignment.

It would be awesome if the dialog box had a third choice such as Yes / No / Re-Assign, so you could easily change the device to the new circuit. Right now, you have to cancel out the wiring operation, open the properties for the device, clear the circuit assignment and then return to wiring.


Thanks.
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.