AutoCAD MEP Wishes

AutoCAD MEP Wishes

Reply
Valued Contributor
Mark_Richards
Posts: 51
Registered: ‎10-02-2008
Message 1 of 2 (556 Views)

Electrical Load calculation options

556 Views, 1 Replies
10-27-2008 03:11 PM
In circuit manager; the ability to toggle a circuit to have its load be calculated "by device" as it is now, or "by circuit" with the ability to specify a circuit load irregardless of the connected devices. If "by circuit" was selected, the user would have two options; first, specify a fixed load for the circuit, this would be useful in areas like a dwelling unit kitchen where the code requires a specific load to be used per circuit. Second; some way to specify a load by area, perhaps a tick box in circuit manager to select multiple circuits to be part of a group which would equally share a specified total load for the entire "loadgroup style". This would be beneficial when designing to the code which requires a particular load per square foot.

In broad strokes, some load calculation functionality that aligns with the NEC, so one could opt to use connected load or calculated load (by area, Etc.)

Thanks.
Valued Contributor
Mark_Richards
Posts: 51
Registered: ‎10-02-2008
Message 2 of 2 (448 Views)

Re: Electrical Load calculation options

04-18-2013 12:18 PM in reply to: Mark_Richards

Four and a half years later.... Still asking.

 

C'mon Autodesk... What about the E in MEP??

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.