AutoCAD MEP Wishes

Reply
New Member
dennishansen
Posts: 1
Registered: ‎10-06-2012
Message 1 of 1 (1,131 Views)

Counting bends in a conduit run

1131 Views, 0 Replies
10-06-2012 10:02 AM

I  use MEP AutoCad  to 3D model conduit runs. Does MEP have a option that  after I finish modeling a conduit run it would tell me how many degrees I have put into that conduit run.National electrical code requires that no conduit  run have more than 360 dgrees.After that a pull box is required .It would help if as I run the conduit throughout the building ,if I exceed the 360 degrees it would  prompt me that a pull bow is requred.Or another way if after I finish the run I have a option that would add the pull boxes as needed.Any help?

Regards,

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Are You Going To Be @ AU 2014? Feel free to drop by our AU topic post and share your plans, plug a class that you're teaching, or simply check out who else from the community might be in attendance. Ohh and don't forgot to stop by the Autodesk Help | Learn | Collaborate booths in the Exhibit Hall and meet our community team if you get a chance!