AutoCAD MEP Wishes

New Member
Posts: 1
Registered: ‎10-06-2012
Message 1 of 1 (1,119 Views)

Counting bends in a conduit run

1119 Views, 0 Replies
10-06-2012 10:02 AM

I  use MEP AutoCad  to 3D model conduit runs. Does MEP have a option that  after I finish modeling a conduit run it would tell me how many degrees I have put into that conduit run.National electrical code requires that no conduit  run have more than 360 dgrees.After that a pull box is required .It would help if as I run the conduit throughout the building ,if I exceed the 360 degrees it would  prompt me that a pull bow is requred.Or another way if after I finish the run I have a option that would add the pull boxes as needed.Any help?


Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.