AutoCAD MEP Wishes

Reply
Contributor
kenzco
Posts: 12
Registered: ‎04-18-2008
Message 1 of 1 (995 Views)

Cast Iron Reducing TEE's & 90's

995 Views, 0 Replies
03-01-2011 02:03 PM

This is the biggest no-brainer for improvement......  Since when does a contractor install a straight tee or 90 then a reducing coupling to make up the smaller diameter...  Drawing pipe takes twice as long because of this flaw & three times as long for re-draws.....  Most of the time I erase and start over.   PLEASE FIX THIS!

 

Thanks!
     

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.