AutoCAD MEP General Discussion

AutoCAD MEP General Discussion

Reply
Active Member
7 Posts
0 Kudos
Registered: ‎01-06-2010
Post 1 of 4

Unreconciled new layers

7314 Views, 3 Replies
01-06-2010 09:46 AM
Hi, anyone know how fix the message unreconciled new layers in mep 2009, its quiet annoying evrytime specially when I am doing plotting.
Active Contributor
41 Posts
0 Kudos
Registered: ‎11-10-2009
Post 2 of 4

Re: Unreconciled new layers

01-06-2010 01:11 PM in reply to: kenlei
command is LAYEREVAL, set to zero....only way i know is to do each dwg, not a global command
Active Member
7 Posts
0 Kudos
Registered: ‎01-06-2010
Post 3 of 4

Re: Unreconciled new layers

01-07-2010 02:53 AM in reply to: kenlei
it works, thanks a lot..
Active Contributor
31 Posts
0 Kudos
Registered: ‎10-12-2007
Post 4 of 4

Re: Unreconciled new layers

02-05-2010 07:37 AM in reply to: kenlei
hello,

Just thought I'd put my two cents in... I believe there is a universal way of removing unreconciled layers. I think you go under layer manager and then go to settings... Turn off evaluate new layers check box. that should do it. Not sure if it carries over projects but you shouldnt have to worry about it when in that particular project again.

Hope it works,

mike
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD MEP Category!

The AutoCAD MEP forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.