AutoCAD MEP General Discussion

AutoCAD MEP General Discussion

Reply
Active Contributor
31 Posts
0 Kudos
Registered: ‎09-30-2008
Post 1 of 3

Showing hidden center lines in ducts going down

258 Views, 2 Replies
03-16-2012 01:20 PM

Hello,

how can i show the center lines in the duct that goes downwards hidden?  I do have the round part of the duct that is hidden showing that way but the centerlines show as cont. lines.  Does anybody have a solution to this?

Thanks

Silvia

Contributor
11 Posts
0 Kudos
Registered: ‎01-28-2010
Post 2 of 3

Re: Showing hidden center lines in ducts going down

03-20-2012 07:52 AM in reply to: silviaberian

I believe that is a block. Poke around in the rise and drop styles under HVAC Objects in the Styles manager.

Product Support
519 Posts
16 Kudos
Registered: ‎08-23-2006
Post 3 of 3

Re: Showing hidden center lines in ducts going down

04-04-2012 06:36 AM in reply to: johnc1s

The centerpoint that represents where the center line goes down in a rise-drop block is mapped to a non-plot layer.  It is necessary to be able to select vertical segments in a selection set.  It also is handy if you need to Osnap to the center.  It should not plot unless someone changes the layer inside the rise-drop block itself.



Joshua Benoist, PE
Senior Support Specialist
Product Support
Autodesk, Inc.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD MEP Category!

The AutoCAD MEP forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Announcements
Are you interested in helping shape the future of the Autodesk Community? To participate in this brief usability study, please click here. Your time and input is greatly appreciated!