AutoCAD MEP General Discussion

AutoCAD MEP General Discussion

*Chris Shoemaker
Message 1 of 2 (184 Views)

Schemetic Lines Snaping to Connectors when they shouldn't

184 Views, 1 Replies
06-27-2005 09:23 AM
I've defined some schematic symbols that i'd like to be able to use in riser
diagrams and occasionally on plans during DD phases. The trouble i'm having
is that when trying to draw a schematic line away from the symbol, the line
keeps snapping to the connector even when it shouldn't. On the attached
drawing please try to trace the pline with a schematic line and you'll see
what i mean. Any ideas?

Active Contributor
Posts: 32
Registered: ‎03-17-2003
Message 2 of 2 (155 Views)

Re: Schemetic Lines Snaping to Connectors when they shouldn't

08-20-2012 05:02 AM in reply to: *Chris Shoemaker

I have the same problem with AMEP 2012, did you ever solve this?


Kind regards Patrik

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD MEP Category!

The AutoCAD MEP forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.