To modify the length and width of the parts, you need to modify the blocks
that make up the MvParts themselves.
Take a look at the tutorials under Content Tools Tutorial -> Using the
Content Builder -> Lesson 1: Creating a block-based MvPart to start to get a
handle on the creation of MvParts.
After you've been through the tutorial please post back with your questions.
jason
"Buster1379"
wrote in message
news:f17866d.-1@WebX.maYIadrTaRb...
> I need to use the Gas Rooftop A/C Units MVpart, but I want to change the
overall length and width of the unit and the size and locations of the duct
connectors to match my catalog equipemnt cut. How do I go about doing this
without chnaging the existing part sizes.
> PS If this works I could then post it to any future MVpart group.
>