I have found why I couldn't snap. The drawing had layer 0 frozen. I don't
understand why this would cause me a problem but it did. Any ideas on why
you can't do this??
Sam
"Sam Nation" wrote in message
news:3fdf284a_5@statler...
> I have already tried this. whiparc was already set to 0.
>
> Sam
> "Dean Saadallah" wrote in message
> news:3fdf277a_3@statler...
> > WHIPARC, set it to zero then REGENALL, see if that helps.
> >
> > --
> > Dean Saadallah
> > Add-on products for LT
> > http://www.pendean.com/lt
> > --
> >
> >
>
>