AutoCAD MEP General Discussion

AutoCAD MEP General Discussion

Reply
*scott
Message 1 of 1 (91 Views)

mvpart water heater

91 Views, 0 Replies
08-03-2003 11:18 PM
I have inserted a water heater from the plumbing mvparts catalog. When I use
the compass and select the 90 degree angle only one line is shown down the
middle of the water heater. The top and bottom lines are shown. Is their a
fix for this?

Scott
RGD
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD MEP Category!

The AutoCAD MEP forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.