AutoCAD MEP General Discussion

AutoCAD MEP General Discussion

Reply
Active Contributor
reno323
Posts: 40
Registered: ‎12-11-2009
Message 1 of 1 (183 Views)

MVPart Visibility Parameter

183 Views, 0 Replies
12-13-2011 06:47 AM

Is there any way to add a visiblity parameter to a block based MVpart (e.g. Suction diffuser on pump on/off or clearances for a VAV box on/off)? I know there are visiblity states in Dynamic blocks, but is there a way to transfer those over to the MVpart created from the block? 

 

Thanks for any help.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD MEP Category!

The AutoCAD MEP forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.