AutoCAD MEP General Discussion

AutoCAD MEP General Discussion

Reply
New Member
cadd1030
Posts: 2
Registered: ‎07-18-2003
Message 1 of 2 (146 Views)

Mechanical Pipe Risers

146 Views, 1 Replies
07-18-2003 12:27 AM
When I draw a pipe and end it with a turn up as a riser the single line drawing shows it as a turn down symbol if I remove any straight pipe connected to the elbow that turns up it shows as a riser symbol. Is there a fix to this besides erasing any vertical pipes on my risers?
Distinguished Contributor
jmcfaddn
Posts: 399
Registered: ‎12-01-2003
Message 2 of 2 (146 Views)

Re: Mechanical Pipe Risers

07-18-2003 03:56 AM in reply to: cadd1030
Have you tried to change the flow direction? Select the riser pipe, right click mouse, select set flow, then select reverse. See if that changes your riser symbol.

Let me know.
Jmcfaddn
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD MEP Category!

The AutoCAD MEP forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.