AutoCAD MEP General Discussion

AutoCAD MEP General Discussion

Reply
New Member
cadd1030
Posts: 2
Registered: ‎07-18-2003
Message 1 of 2 (143 Views)

Mechanical Pipe Risers

143 Views, 1 Replies
07-18-2003 12:27 AM
When I draw a pipe and end it with a turn up as a riser the single line drawing shows it as a turn down symbol if I remove any straight pipe connected to the elbow that turns up it shows as a riser symbol. Is there a fix to this besides erasing any vertical pipes on my risers?
Distinguished Contributor
jmcfaddn
Posts: 399
Registered: ‎12-01-2003
Message 2 of 2 (143 Views)

Re: Mechanical Pipe Risers

07-18-2003 03:56 AM in reply to: cadd1030
Have you tried to change the flow direction? Select the riser pipe, right click mouse, select set flow, then select reverse. See if that changes your riser symbol.

Let me know.
Jmcfaddn
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD MEP Category!

The AutoCAD MEP forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Announcements
Are You Going To Be @ AU 2014? Feel free to drop by our AU topic post and share your plans, plug a class that you're teaching, or simply check out who else from the community might be in attendance. Ohh and don't forgot to stop by the Autodesk Help | Learn | Collaborate booths in the Exhibit Hall and meet our community team if you get a chance!