AutoCAD MEP General Discussion

Reply
Active Member
mattgsi
Posts: 9
Registered: ‎12-18-2012
Message 1 of 1 (233 Views)

Isometric Snap

233 Views, 0 Replies
01-07-2013 07:32 AM

Can anyone tell me why when I set my snap to isometric snap and then draw a line, it does not follow the exact isometric angle so my snap is then rendered useless?  The only way I have found to be able to draw things isometrically and still utilize snap is to make sure that ortho and polar are off which makes it very difficult when drawing long isometric lines.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD MEP Category!

The AutoCAD MEP forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.