AutoCAD MEP General Discussion

AutoCAD MEP General Discussion

Reply
Contributor
duran492
Posts: 12
Registered: ‎05-13-2011
Message 1 of 2 (224 Views)

HELP! on pasting 1 block to multiple nodes at one time!?!?!

224 Views, 1 Replies
08-17-2012 02:57 PM

i have a block of a hanger point that i created.

 

All the hanger blocks that i created have an X at the top where the strap screws into a deck or stud etc..

 

The X, acts a center point for me to paste my hanger point from it's node and be dead on for layout purposes.

 

 

Is there any way to paste my hanger point to all the X's i have through out the drawing?

 

 i have over 2500 hangers that have an X as the center point of a rod. For me to individually paste each one would seem like it would take an eternity. Im looking for an easier way to paste one node of a block on to the 2500 center points.

 

HELP ahaha!!<!?!?!?!

 

 

Active Member
petrocelli718
Posts: 7
Registered: ‎02-18-2009
Message 2 of 2 (204 Views)

Re: HELP! on pasting 1 block to multiple nodes at one time!?!?!

08-20-2012 01:46 PM in reply to: duran492

simple,

 

Is the existing X a block that will only contain the Hanger?

 

simply edit the existing X refference block to inclued the Hanger... this seems to be very east

 

I hope this works for you

 

Regards,

 

 

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD MEP Category!

The AutoCAD MEP forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Announcements
Are You Going To Be @ AU 2014? Feel free to drop by our AU topic post and share your plans, plug a class that you're teaching, or simply check out who else from the community might be in attendance. Ohh and don't forgot to stop by the Autodesk Help | Learn | Collaborate booths in the Exhibit Hall and meet our community team if you get a chance!