AutoCAD MEP General Discussion

AutoCAD MEP General Discussion

Reply
Valued Contributor
mjmpe
Posts: 73
Registered: ‎02-14-2011
Message 1 of 1 (215 Views)

GROOVED PIPE CONNECTIONS

215 Views, 0 Replies
01-02-2013 10:02 AM

I am drwg in MEP 2013. and drwg with grooved pipe I find it hard to designate where exactly the finally connection is on the fittings, when you look in close there are two little dots on the fittings and when you hover over it gives you two pipe curve connections, How do you know exactly where the final connection should be/ some of my measures are coming out 1/8" difference, I know its not much but would like it to be accurate. also when you draw the pipe between two fittings it doesn't look like the pipe is into the grooved coupling/ fitting how come?

 

thanks

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD MEP Category!

The AutoCAD MEP forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.