I am drwg in MEP 2013. and drwg with grooved pipe I find it hard to designate where exactly the finally connection is on the fittings, when you look in close there are two little dots on the fittings and when you hover over it gives you two pipe curve connections, How do you know exactly where the final connection should be/ some of my measures are coming out 1/8" difference, I know its not much but would like it to be accurate. also when you draw the pipe between two fittings it doesn't look like the pipe is into the grooved coupling/ fitting how come?
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions to get help installing your software.
The AutoCAD MEP forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.
Upgrading to a 2015 product? Make sure to check these out 1st!