AutoCAD MEP General Discussion

AutoCAD MEP General Discussion

Reply
Valued Contributor
toddn
Posts: 70
Registered: ‎11-24-2003
Message 1 of 1 (76 Views)

Duct Transitions

76 Views, 0 Replies
08-18-2003 01:46 AM
We manufacture all of our duct transitions to be at a 30 degree angle. What would be the correct equation to enter into the Catalog Editor for this to become the default. I know you can change the transition and then enter the degrees but we want it to add the correct transition automatically.
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD MEP Category!

The AutoCAD MEP forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Announcements
Are You Going To Be @ AU 2014? Feel free to drop by our AU topic post and share your plans, plug a class that you're teaching, or simply check out who else from the community might be in attendance. Ohh and don't forgot to stop by the Autodesk Help | Learn | Collaborate booths in the Exhibit Hall and meet our community team if you get a chance!