Community
AutoCAD MEP Forum
Welcome to Autodesk’s AutoCAD MEP Forums. Share your knowledge, ask questions, and explore popular AutoCAD MEP topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

duct sizing

1 REPLY 1
Reply
Message 1 of 2
walter1959
514 Views, 1 Reply

duct sizing

hi, this might seem like a stupid question but i am just learning hvac on mep 2013 and the duct sizes sometimes come out in half sizes such as 13-1/2". i have set the flow rates on the diffusers and no matter what i try, i can't seem to get it to come out in straight sizes. am i missing a step?

1 REPLY 1
Message 2 of 2
Keith.Brown
in reply to: walter1959

Sounds like you are using the duct size calculator.  If you are then you can set it to use whole inch increments.  This is done by using the USE CATALOG SIZES dropdown as shown in the picture below and selecting "1 inch increment".

 

Duct Calculator.jpg

 

 

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report

”Boost