AutoCAD MEP General Discussion

AutoCAD MEP General Discussion

New Member
Posts: 1
Registered: ‎08-23-2012
Message 1 of 2 (301 Views)

duct sizing

301 Views, 1 Replies
08-23-2012 11:00 AM

hi, this might seem like a stupid question but i am just learning hvac on mep 2013 and the duct sizes sometimes come out in half sizes such as 13-1/2". i have set the flow rates on the diffusers and no matter what i try, i can't seem to get it to come out in straight sizes. am i missing a step?

*Expert Elite*
Posts: 1,195
Registered: ‎03-13-2008
Message 2 of 2 (294 Views)

Re: duct sizing

08-23-2012 12:48 PM in reply to: walter1959

Sounds like you are using the duct size calculator.  If you are then you can set it to use whole inch increments.  This is done by using the USE CATALOG SIZES dropdown as shown in the picture below and selecting "1 inch increment".


Duct Calculator.jpg



Keith Brown AutoCAD MEP BLOG | RSS Feed
AutoCAD MEP 2014 | Revit 2014 | EastCoast CAD/CAM V6.1 | Visual Studio 2013
⁞|⁞ Please use Mark Solutions!.Accept as Solution and Give Kudos!Give Kudos as appropriate. Thank you!
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD MEP Category!

The AutoCAD MEP forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Are You Going To Be @ AU 2014? Feel free to drop by our AU topic post and share your plans, plug a class that you're teaching, or simply check out who else from the community might be in attendance. Ohh and don't forgot to stop by the Autodesk Help | Learn | Collaborate booths in the Exhibit Hall and meet our community team if you get a chance!