AutoCAD MEP General Discussion

AutoCAD MEP General Discussion

Reply
Active Member
CAVEMANED
Posts: 7
Registered: ‎02-03-2010
Message 1 of 2 (426 Views)

Duct Size Calculator Issue

426 Views, 1 Replies
03-17-2011 08:22 AM
I'm having an issue with the Duct Size Calculator. After I run it, the Extended Data reads the flow through the duct in cu m/s instead of cfm and similarly for friction. How do I change that? When I draw the duct it says CFM in the dialog box. Until I run the Duct Size Calculator, the duct doesn't read any flow at all. What am I missing, or how do I change the units in the Duct Size Calculator?
Contributor
Leon-Biohazard
Posts: 20
Registered: ‎06-21-2010
Message 2 of 2 (415 Views)

Re: Duct Size Calculator Issue

03-17-2011 07:32 PM in reply to: CAVEMANED

In fact, you don't need to concern the flow unit shown on extended data before calculation. It's just the default unit of flow, but after calculation, it's the definite unit.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD MEP Category!

The AutoCAD MEP forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.