AutoCAD MEP General Discussion

Reply
Active Contributor
clarkm
Posts: 38
Registered: ‎12-08-2003
Message 1 of 2 (96 Views)

Diffuser Tags

96 Views, 1 Replies
07-21-2003 03:18 AM
The diffuer tags seem to only accept numbers for CFM rates. Lots of times we use a plenum transfer return grille & do not list a CFM rate, we use a dash instead. Is there any way of getting the tags accept this value?
*[Autodesk], jason martin
Message 2 of 2 (96 Views)

Re: Diffuser Tags

07-21-2003 10:01 PM in reply to: clarkm
The diffuser tag uses an automatic property of the diffuser to get the cfm.
You can modify this by editing the property set definition for the diffuser.

Currently the MvParts-AirTerminalObjects property set has an automatic
property called CFM-Act. You can delete this automatic property and create a
new manual property with the same name set it's type to text and you will be
able to enter whatever you want in the field.

hth

jason

"clarkm" wrote in message
news:f17974e.-1@WebX.maYIadrTaRb...
> The diffuer tags seem to only accept numbers for CFM rates. Lots of times
we use a plenum transfer return grille & do not list a CFM rate, we use a
dash instead. Is there any way of getting the tags accept this value?
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD MEP Category!

The AutoCAD MEP forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.