AutoCAD MEP General Discussion

AutoCAD MEP General Discussion

Reply
New Member
fouad.issa
Posts: 2
Registered: ‎02-21-2011
Message 1 of 2 (394 Views)

Bottom of Conduit Elevation Dynamic Property Field

394 Views, 1 Replies
06-01-2012 03:04 PM

Hello, Is there a way to add a property field to conduits/pipes that would allow the input of "Bottom of Conduit" value as supposed to the default "Elevation" field that picks the center of conduit?

The intent is that when I select multiple conduits and input an elevation, all conduits will be aligned to the bottom.

 

Thanks in advance!

 

-Fouad

Active Member
timmyt21
Posts: 9
Registered: ‎07-22-2012
Message 2 of 2 (294 Views)

Re: Bottom of Conduit Elevation Dynamic Property Field

10-01-2012 09:58 AM in reply to: fouad.issa

I need this as well. I can't figure anyway to do this. I'm getting really pissed off at Revit. Especially when I'm running racks with 70 conduits on it.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD MEP Category!

The AutoCAD MEP forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.