AutoCAD MEP General Discussion

AutoCAD MEP General Discussion

Valued Contributor
Posts: 71
Registered: ‎04-18-2011
Message 1 of 2 (206 Views)

Bottom of Cable Tray Measurement

206 Views, 1 Replies
04-10-2012 09:07 AM

Hi all,


Is there a way to automatically label the height to the bottom of the cable tray, as can be done with the ductwork? I've looked in the style manager/label curves and there are cable tray options, but only supplier name is shown as being an option. Is there a way to do this?


Whilst on the subject of cable tray, I've had a bit of a whinge before (as have many others) about the cable tray inverting itself and being more difficult than it should be to work with, have any people with 2013 found any differences? I have 2013 ready to install and hopefully this will finally be put to bed....holds breath....



Distinguished Contributor
Posts: 116
Registered: ‎03-01-2008
Message 2 of 2 (183 Views)

Re: Bottom of Cable Tray Measurement

04-16-2012 01:11 AM in reply to: s.lawrence

Still crap I'm afraid.



Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD MEP Category!

The AutoCAD MEP forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Are You Going To Be @ AU 2014? Feel free to drop by our AU topic post and share your plans, plug a class that you're teaching, or simply check out who else from the community might be in attendance. Ohh and don't forgot to stop by the Autodesk Help | Learn | Collaborate booths in the Exhibit Hall and meet our community team if you get a chance!