AutoCAD MEP General Discussion

Reply
Member
sbarber
Posts: 4
Registered: ‎08-14-2003
Message 1 of 1 (64 Views)

Air Terminals

64 Views, 0 Replies
08-14-2003 02:06 AM
I need 2 quick parts - one for an 8x8 air terminal and one for a 12x12...any way to take the standard 18x18 and adjust it without going through and exploding, editing, etc?

I thought that ABS2 or ABS 3 had a parmetric one...which would be the ultimate answer.

Any thoughts or help is greatly appreciated



Sylvia
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD MEP Category!

The AutoCAD MEP forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.