AutoCAD MEP General Discussion

AutoCAD MEP General Discussion

Reply
Valued Contributor
toddn
Posts: 70
Registered: ‎11-24-2003
Message 1 of 2 (86 Views)

45 Degree Later Duct Tees

86 Views, 1 Replies
08-20-2003 04:52 AM
I have posted a few times and have never been really given an answer as to why 45 Degree Later Duct Tees were not default parts in Building Systems 2004. To make matters worse is that, when I was looking through the Schematic Symbols library, many later tees appear. Why are there lateral tee details in this menu but NO lateral tees in the Duct menu? Please explain this to me. Is there any plan to add these tees to future upgrades? There is not a job that goes by that we don't use lateral tees. I inquired about it and was told that a lateral tee could be built for me but it would cost $150. Please somebody explain this to me!!!!
Valued Contributor
advandes
Posts: 90
Registered: ‎12-10-2003
Message 2 of 2 (86 Views)

Re: 45 Degree Later Duct Tees

08-26-2003 02:05 AM in reply to: toddn
...yes, and please explain it to me too.

Aaron
Aaron A. Gray
Advance Design
369 Sagamore Drive
Rochester, NY 14617
585-734-8277
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD MEP Category!

The AutoCAD MEP forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.