As shown in the attachment, I want my elbow down to be displayed as a half circle. I can't figure out why sometimes a full circle is shown. It's the same pipe run in the same file, dropping/rising to the same elevations but one elbow is shown correctly and the other is not. Has anyone had this issue, is there a solution?
Display Settings: Representation by object->Pipe->Plan Everything is turned off except contour and centerline. (same applies for "pipe fitting")
Plot Style: As Displayed
Add on software - East Coast MEP
![Autodesk Design & Make Report](https://forums.autodesk.com/t5/image/serverpage/image-id/1350519iCB55845EBFC43016/image-size/large?v=v2&px=999" "Autodesk Design & Make Report")
