AutoCAD Mechanical General Discussion

AutoCAD Mechanical General Discussion

Reply
Contributor
12 Posts
0 Kudos
Registered: ‎12-30-2007
Post 11 of 13

Re: PROBLEM 3D CONNEXION CONTROLLER BUT INTERFERES WITH AUTOCAD MECHANICAL

10-19-2011 04:29 AM in reply to: tdigiannurio

if the problem i srelated to touching 3D connexion controller in Autocad 2011 or 2012 try typing the command 'PLAN" and then the command "world" and that should strighten out the drawing. I have never had a situation where the ndrawing was unusable.

Contributor
12 Posts
0 Kudos
Registered: ‎12-30-2007
Post 12 of 13

Re: PROBLEM 3D CONNEXION CONTROLLER BUT INTERFERES WITH AUTOCAD MECHANICAL

10-19-2011 04:30 AM in reply to: VinodBalasubramanian

I have upodate one installed and the problem ihas NOT been  addressed

Contributor
12 Posts
0 Kudos
Registered: ‎12-30-2007
Post 13 of 13

Re: PROBLEM 3D CONNEXION CONTROLLER BUT INTERFERES WITH AUTOCAD MECHANICAL

10-19-2011 04:35 AM in reply to: VinodBalasubramanian

This issue has been reported by me through my subscription to Autodesk support. I have been only told there they are aware of the problem and they are working on it. But my concern is there enough emphasis on this problem by others. I assume that the "squeeky wheel gets the most oil" principle applies here.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post