AutoCAD Mechanical General Discussion

AutoCAD Mechanical General Discussion

Reply
Contributor
tdigiannurio
Posts: 12
Registered: ‎12-30-2007
Message 11 of 13 (115 Views)

Re: PROBLEM 3D CONNEXION CONTROLLER BUT INTERFERES WITH AUTOCAD MECHANICAL

10-19-2011 04:29 AM in reply to: tdigiannurio

if the problem i srelated to touching 3D connexion controller in Autocad 2011 or 2012 try typing the command 'PLAN" and then the command "world" and that should strighten out the drawing. I have never had a situation where the ndrawing was unusable.

Contributor
tdigiannurio
Posts: 12
Registered: ‎12-30-2007
Message 12 of 13 (115 Views)

Re: PROBLEM 3D CONNEXION CONTROLLER BUT INTERFERES WITH AUTOCAD MECHANICAL

10-19-2011 04:30 AM in reply to: VinodBalasubramanian

I have upodate one installed and the problem ihas NOT been  addressed

Contributor
tdigiannurio
Posts: 12
Registered: ‎12-30-2007
Message 13 of 13 (115 Views)

Re: PROBLEM 3D CONNEXION CONTROLLER BUT INTERFERES WITH AUTOCAD MECHANICAL

10-19-2011 04:35 AM in reply to: VinodBalasubramanian

This issue has been reported by me through my subscription to Autodesk support. I have been only told there they are aware of the problem and they are working on it. But my concern is there enough emphasis on this problem by others. I assume that the "squeeky wheel gets the most oil" principle applies here.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Are You Going To Be @ AU 2014? Feel free to drop by our AU topic post and share your plans, plug a class that you're teaching, or simply check out who else from the community might be in attendance. Ohh and don't forgot to stop by the Autodesk Help | Learn | Collaborate booths in the Exhibit Hall and meet our community team if you get a chance!