AutoCAD Mechanical General Discussion

AutoCAD Mechanical General Discussion

Reply
Valued Contributor
Mike686
Posts: 97
Registered: ‎03-28-2011
Message 1 of 2 (216 Views)
Accepted Solution

Hide situation and constraint geometry

216 Views, 1 Replies
10-29-2012 06:21 AM

hi everyone, i have a problem with the hide situation

i have a drawing witch containt constraint geometry and block..

when i try to do a hide situation, when i select one of the constraint geometry it always said

"1 found

1 was filtered out"

so i can't select anything for the hide situation

 

is there limitation to the hide situation for constraint geometry??

Product Design Suite 2013

Hi,

 

Yes, this is a limitation. Hide situation will filter out constraint geometry. You need to remove constraint from the geometry first and then you can select it. I'll log a wish item in our system to track this issue.

Employee
michaelsu
Posts: 483
Registered: ‎07-11-2008
Message 2 of 2 (199 Views)

Re: Hide situation and constraint geometry

10-29-2012 07:24 PM in reply to: Mike686

Hi,

 

Yes, this is a limitation. Hide situation will filter out constraint geometry. You need to remove constraint from the geometry first and then you can select it. I'll log a wish item in our system to track this issue.

Thanks.
Michael Su
SQA Engineer
Autodesk
------------------------------------------------------------------------------------------------------
Please mark any response as "Accept as Solution" if it answers your question.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.