Convert a Spline to a line or explode

[asi_fw]

Need to save a dwg as a dxf for use on our burntable which then converts a dxf to a G Code program however my drawing contains splines which I cannot seem to explode into lines. The burntable program does not play well with splines or polylines. Any ideas

[Anonymous]

You can convert a spline to a polyline, then
explode the p'line.  2010 has that as part of PEDIT.  If you aren't
using 2010, search the internet.  There are lisp apps out there that will
do it.

style="PADDING-RIGHT: 0px; PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: #000000 2px solid; MARGIN-RIGHT: 0px">

<asi_fw> wrote in message
href="news:6167584@discussion.autodesk.com">news:6167584@discussion.autodesk.com...

Need
to save a dwg as a dxf for use on our burntable which then converts a dxf to a
G Code program however my drawing contains splines which I cannot seem to
explode into lines. The burntable program does not play well with splines or
polylines. Any ideas

[Anonymous]

Hey,

if you save as DXF R12 file, then splines are
automatically converted to polylines, because in version 12 splines does not
exists.

hope that hepls.

regards

Markus

style="PADDING-RIGHT: 0px; PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: #000000 2px solid; MARGIN-RIGHT: 0px">

<asi_fw> wrote in message
href="news:6167584@discussion.autodesk.com">news:6167584@discussion.autodesk.com...

Need
to save a dwg as a dxf for use on our burntable which then converts a dxf to a
G Code program however my drawing contains splines which I cannot seem to
explode into lines. The burntable program does not play well with splines or
polylines. Any ideas