AutoCAD Map 3D General Discussion

AutoCAD Map 3D General Discussion

Reply
Contributor
Peter_NDNG
Posts: 11
Registered: ‎02-22-2012
Message 1 of 2 (220 Views)

Xref Scale

220 Views, 1 Replies
09-26-2012 12:40 PM

I'm adding all our old asbuilt drawings to a map project I'm working on, but I'm having a problem with scaling when I xref the building drawings in.  Sometimes when I add them in they come in with a reasonable scale, but other times, no matter what scale I put or the insertion point I use the drawing ends up being tiny and (it has a geographic projection) thousands, if not millions of miles off, and I have to zoom to the extent and look for this tiny speck that is the xref.  Sometimes I can transform it by zooming in and out and placing the tie points.  But lately the scale has been so weird that once I find the xref Map3D won't let me zoom into the full extent of the map I've made, making the task impossible.

 

Has anyone had this problem, or know how to remedy it?

Active Member
coalprpmapper
Posts: 10
Registered: ‎09-02-2004
Message 2 of 2 (183 Views)

Re: Xref Scale

10-01-2012 02:00 PM in reply to: Peter_NDNG

Do your xrefs have the same units as the drawing you're trying to xref into?  If the two files use a different "insertion scale", then the xref is automatically scaled, unless one of them is set to "unitless" in your Options dialog box, User Preferences Tab.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.