AutoCAD Map 3D General Discussion

AutoCAD Map 3D General Discussion

Reply
Active Contributor
amm30165
Posts: 42
Registered: ‎03-25-2008
Message 1 of 2 (218 Views)

viewport is blank when creating a raster image

218 Views, 1 Replies
06-29-2012 11:10 AM

I am using MAP3D 2013 and trying to create a raster image file for use in anther document (the document will not accept a dwg or dwf file, only a raster image).

When I use the JPGOUT (or PNGOUT or BMPOUT or TIFOUT) command I can select all of the objects and viewport; there is no problem creating the file.  But when I open up the raster image, only the viewport outline and objects in paperspace have come accross; the viewport appears empty. 

 

In MAP, the viewport is turned on and I can see everything as intended.

 

Any suggestions?

Alicia
*Expert Elite*
antoniovinci
Posts: 1,701
Registered: ‎06-03-2011
Message 2 of 2 (208 Views)

Re: viewport is blank when creating a raster image

06-30-2012 04:39 AM in reply to: amm30165

1] _PLOTTERMANAGER

2] add the TIFF UNCOMPRESSED device

3] plot to file by means of that virtual printer

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.