AutoCAD Map 3D General Discussion

AutoCAD Map 3D General Discussion

New Member
Posts: 1
Registered: ‎03-29-2012
Message 1 of 2 (253 Views)

shapefile in data connect

253 Views, 1 Replies
03-29-2012 01:05 PM

I am just wondering how to print the attribute from a shapefile that is attched to drawing using data connect.

I can see the attrubute on the preview but it is not printing.





Posts: 3
Registered: ‎03-29-2012
Message 2 of 2 (248 Views)

Re: shapefile in data connect

03-29-2012 02:12 PM in reply to: CorpuzNolan7590

I am having the same problem. Even got the point to where the dynamic text quite showing up completely. Here is what I have learned.


Dynamic text can be converted into Mtext. Go to the Annotate tab then to the Text tab. From there you can convert all dynamic text to Mtext.


Once this is done, the text will no longer behave as Dynamic text and will not act as it had before with your scale ranges.


This is the best way to control the text when going to plot.


Hope this helps.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.