AutoCAD Map 3D General Discussion

AutoCAD Map 3D General Discussion

Reply
New Member
rbreaux
Posts: 1
Registered: ‎07-31-2012
Message 1 of 4 (255 Views)

Printing Problems

255 Views, 3 Replies
10-05-2012 09:33 AM

I am having problems printing from AC 2013. In one drawing I can print 42" x 380" with no problem but then I open a new drawing and try printing 42" x 315" AC doesn't send it to the printer. In the 42" x 315" drawing if I set my paper lower than 300" it prints fine. Any leads on how I can fix this?

*Expert Elite*
Alfred.NESWADBA
Posts: 9,598
Registered: ‎06-29-2007
Message 2 of 4 (247 Views)

Re: Printing Problems

10-05-2012 10:13 PM in reply to: rbreaux

Hi,

 

sounds like a memory issue, so if the second plot uses more data (especially image-data) than anything happens that may need more memory (more than available).

Try to plot to DWF, it that works then open the DWF with DesignReview and print it to the plotter then.

 

- alfred -

-------------------------------------------------------------------------
Alfred NESWADBA
Ingenieur Studio HOLLAUS ... www.hollaus.at
-------------------------------------------------------------------------
*Expert Elite*
antoniovinci
Posts: 1,782
Registered: ‎06-03-2011
Message 3 of 4 (242 Views)

Re: Printing Problems

10-05-2012 11:17 PM in reply to: rbreaux

If .DWF fails, try to virtually print to a PDF file, then send it to the plotter from Adobe Reader.

*Expert Elite*
Alfred.NESWADBA
Posts: 9,598
Registered: ‎06-29-2007
Message 4 of 4 (239 Views)

Re: Printing Problems

10-05-2012 11:44 PM in reply to: antoniovinci

Hi,

 

and if you need to try PDF then don't use Adobe therefor, because Adobe-Printer and the format 315" fails before it starts (IMHO) :smileywink:

 

- alfred -

-------------------------------------------------------------------------
Alfred NESWADBA
Ingenieur Studio HOLLAUS ... www.hollaus.at
-------------------------------------------------------------------------
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.