AutoCAD Map 3D General Discussion

AutoCAD Map 3D General Discussion

Reply
Valued Contributor
57 Posts
0 Kudos
Registered: ‎06-01-2006
Post 1 of 3

polylines and object data

144 Views, 2 Replies
09-13-2006 02:10 PM
I need to change the direction of polylines but want to keep the object data attached. I've tried plrev.lsp but the object data does not stay with the polyline once the direction s reversed. Any suggestions will be appreciated.

Re: polylines and object data

09-13-2006 02:17 PM in reply to: svest_2001
A simple way would be offset or copy the pline, run plrev.lsp then the
copyod.lsp in the MAP sample folder to copy the OD back and erase the copied
pline.

Murph
--
http://mappingitout.blogspot.com/
wrote in message news:5328290@discussion.autodesk.com...
I need to change the direction of polylines but want to keep the object data
attached. I've tried plrev.lsp but the object data does not stay with the
polyline once the direction s reversed. Any suggestions will be
appreciated.
*Sanjay Jamalpur
Post 3 of 3

Re: polylines and object data

12-28-2006 08:36 PM in reply to: svest_2001
Hello,
You can have your task done of reversing the polyline direction and
retianing the object data. By using command "GT_Flip" which
is in our product "GeoTools". You may want to give this a try and see for
yourself.

For a FREE 30 days evaluation download visit our website at
http://www.4d-technologies.com/geotools

Here is a short description of the command "GT_Flip" along with the GUI

Reverses the direction of the polyline vertices. This command preserves the
handle (see below for conditions) as well as any extended entity data that
is stored with the polyline or with each or any of its vertices (in case of
heavy weight polylines).


--
Sanjay Jamalpur
- Four Dimension Technologies
[www.4d-technologies.com]
- Get GeoTools, Work smarter: www.4d-technologies.com/geotools
- Free Lisp downloads @ TechCenter: www.4d-technologies.com/techcenter

wrote in message news:5328290@discussion.autodesk.com...
I need to change the direction of polylines but want to keep the object data
attached. I've tried plrev.lsp but the object data does not stay with the
polyline once the direction s reversed. Any suggestions will be
appreciated.
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post