AutoCAD Map 3D General Discussion

AutoCAD Map 3D General Discussion

Reply
Contributor
Gtuni
Posts: 14
Registered: ‎01-05-2006
Message 11 of 12 (115 Views)

Re: Map Crashes with DWG

11-15-2012 08:24 AM in reply to: mekohler

Win7 64bit. Civil 3D 64bit.

 

I have the same problem after using Data Connect to add a polyline shapefile to my drawing.

I would roll off the Data Connect Diloag an onto the shapefile...HANG...CRASH.

 

Thanks to Alfred's suggestion I checked ROLLOVERTIPS and SELECTIONPREVIEW.

ROLLOVERTIPS was set to 0 already, SELECTIONPREVIEW was set to 3, I changed it to 0.

Everything works good now.

 

I checked these two settings in Civil3D 2011, where I have no problems with shapefiles, and ROLLOVERTIPS was set to 0; SELECTIONPREVIEW was set to 3. Those same settings will not work in Civil 3D 2012.

Contributor
Gtuni
Posts: 14
Registered: ‎01-05-2006
Message 12 of 12 (108 Views)

Re: Map Crashes with DWG

11-15-2012 10:20 AM in reply to: Gtuni

Win7 64 bit & Civil3D 2012 64bit

 

Further testing shows that if I use a regualar AutoCAD template when using the Planning andd Analysis' Data Connect to bring in a shapefile, it will hang and crash.

If I use a civil 3D template, no matter what the SELECTIONPREVIEW is set to, it will not hang and crash.

 

In Civil 3D 2011 64bit, it works no matter which template I use.

 

Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.