AutoCAD Map 3D General Discussion

AutoCAD Map 3D General Discussion

Reply
Contributor
GrahamSherwood6686
Posts: 13
Registered: ‎01-09-2007
Message 1 of 2 (159 Views)

Linetype changing scales

159 Views, 1 Replies
06-15-2012 02:48 AM

I am using Map 3D 2013

 

I have several drawings in which I want to use a linetype (centrex2) at a specific scale. The scale setting is exactly the same in all the drawings but in some the linetype is coming out at different scales, all larger, but not the same or to a set factor. All the entities in question are polylines (2d).

 

I have checked in all drawings that:

 

  • global scale factor and current object scale in the linetype manager are the same (1.0)
  • drawing units are the same (unitless)
  • ‘use paper space units for scaling’ is always deselected
  • linetype generation is always enabled

 

Any other suggestions gratefully received

Product Support
luconceicao
Posts: 583
Registered: ‎11-07-2007
Message 2 of 2 (127 Views)

Re: Linetype changing scales

06-19-2012 09:29 AM in reply to: GrahamSherwood6686

Hi Graham,

Do you mind sending a drawing that shows the issue?

Ideally, use eTransmit to create a pack of files that are used by this drawing (in case you are using a custon linetype).

 

Cheers,

Luciane

 

Luciane Conceição
Product Support Specialist
Autodesk, Inc.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.