AutoCAD Map 3D General Discussion

AutoCAD Map 3D General Discussion

Reply
Active Contributor
mikeishman1046
Posts: 49
Registered: ‎05-09-2005
Message 1 of 3 (328 Views)
Accepted Solution

Layer Properties Manager

328 Views, 2 Replies
02-14-2013 07:39 AM

Anyone run into an issue in AutoCAD Map 3D 2012 when multiple raster images (in this case 66 ortho images) are attached as data connections, you cannot see New Layers when you create them in the default Layer Properties Manager?

 

I have found using the Classic Layer Properties Manager is a work around.

 

It doesn’t seem to matter if the ortho images are connected individually or grouped as a single layer.

 

I'm running Map 3D with SP2 applied.

Update; Problem could not be replicated on different system (Autodesk Support Team) using same .dwg file.  Map 3D settings were set to default on my workstation and problem no longer occured. I will re-build my customized workspace and test Layer Properties Manager as I progress with re-build. I will post a follow-up about what if anything occurs.

Active Contributor
mikeishman1046
Posts: 49
Registered: ‎05-09-2005
Message 2 of 3 (300 Views)

Re: Layer Properties Manager

02-15-2013 12:27 PM in reply to: mikeishman1046

Update; Problem could not be replicated on different system (Autodesk Support Team) using same .dwg file.  Map 3D settings were set to default on my workstation and problem no longer occured. I will re-build my customized workspace and test Layer Properties Manager as I progress with re-build. I will post a follow-up about what if anything occurs.

Product Support
phil_borycens
Posts: 202
Registered: ‎10-25-2011
Message 3 of 3 (293 Views)

Re: Layer Properties Manager

02-15-2013 01:23 PM in reply to: mikeishman1046

Yes, running the Reset Settings to Default utility restored Mike's ability to create a new AutoCAD layer again in the Layer Properties Manager for this drawing.



Phil Borycens
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Are You Going To Be @ AU 2014? Feel free to drop by our AU topic post and share your plans, plug a class that you're teaching, or simply check out who else from the community might be in attendance. Ohh and don't forgot to stop by the Autodesk Help | Learn | Collaborate booths in the Exhibit Hall and meet our community team if you get a chance!