AutoCAD Map 3D General Discussion

AutoCAD Map 3D General Discussion

Reply
New Member
alexandra.thomson
Posts: 2
Registered: ‎07-23-2012
Message 1 of 3 (202 Views)

Lat and long

202 Views, 2 Replies
08-07-2012 07:09 AM

So i have a set up prepared of 0degrees 0 minutes E TO 12 degrees E then 0 degrees north to 12 degrees north, how do i input coordinates so i can have an exact position od 3degrees 14 minues E 6 degrees 45 minutes N? massively need help here!!

*Expert Elite*
antoniovinci
Posts: 1,700
Registered: ‎06-03-2011
Message 2 of 3 (175 Views)

Re: Lat and long

08-08-2012 10:55 PM in reply to: alexandra.thomson

Whoa, madame, ain't gotcha...

Please write all again, as you should explain it to your grandmother, slooowly and eaaasy.

Valued Mentor
parkr4st
Posts: 454
Registered: ‎03-24-2004
Message 3 of 3 (167 Views)

Re: Lat and long

08-09-2012 02:43 AM in reply to: antoniovinci

try this format after you start the line

 

@distance<n45d45'45"E

 

 

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.