AutoCAD Map 3D General Discussion

AutoCAD Map 3D General Discussion

Reply
Distinguished Contributor
Vasily_BC
Posts: 106
Registered: ‎04-27-2012
Message 1 of 2 (243 Views)

Incorrect ECW coordinates

243 Views, 1 Replies
09-04-2012 12:42 PM

I've created same topic in Civil 3D, but I think here I'll an answer faster.

 

I have GeoPDF that I can't attach properly to drawing in Civil 3D.

So with Global Mapper I exported it to geo-referenced ECW.

I checked ECW in Global Mapper and ArcMap, everything just fine.

However when I did mapiinsert in Civil 3D, image appeared with shifted coordinates.

The original coordinate system of PDF and ECW is BC/Albers and coordinate grid is Lat/ Longs.

I've uploaded ECW, if somebody could try it.

https://docs.google.com/open?id=0B5LTHGXLBfyscnpfUHlEYm1tczQ

 

This is a picture from Civil 3D with Lat Long grid above the image.

Example.jpg

 

Thanks.

*Expert Elite*
antoniovinci
Posts: 1,703
Registered: ‎06-03-2011
Message 2 of 2 (229 Views)

Re: Incorrect ECW coordinates

09-05-2012 03:39 AM in reply to: Vasily_BC

In my Map2006 CRS list, there is no BC Albers, so I created it by scratch basing on EPSG:3005 parameters (command _ADEDEFCRDSYS).

If I load your .ECW in this brand new CRS, and I draw a draft yellow line on the West coast, it fits exactly on Google Earth - check my .ZIP one, unpacking the content in the .ECW folder.


Now you should try to attach my DWG into a LL84 empty drawing (EPSG:4326) by means of _ADEDRAWINGS, then perform a draw query to check the conversion.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.