AutoCAD Map 3D General Discussion

AutoCAD Map 3D General Discussion

Reply
New Member
christoph.lauber
Posts: 1
Registered: ‎01-12-2010
Message 1 of 1 (88 Views)

Identify map features by clicking in AutoCad Map 2012

88 Views, 0 Replies
03-19-2013 06:35 AM

Hello

 

I'm using Map3D 2012 with Electrical CE module.

 

When I insert a new service point in the Client Interface I'm automatically asked for the orientation. When I insert a minor consumer I'm not asked about the orientation and it is set to the default.

As both objects geometrie are stocked in el_point there can't be the difference. I looked as well in the object rules but can't find any difference. I suppose it must be somethin in the insert-workflow. But where is it regulated? Any ideas?

 

Thanks for hints.

 

Regards Christoph

Christoph Lauber
GeoplanTeam Hutzli + Kluser
Egliweg 6
2560 Nidau
Switzerland
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.