AutoCAD Map 3D General Discussion

AutoCAD Map 3D General Discussion

Reply
Valued Contributor
toolbox2
Posts: 65
Registered: ‎10-24-2001
Message 1 of 2 (154 Views)

How to convert rules to AutoCAD layers

154 Views, 1 Replies
04-27-2012 01:22 AM

I've been given a drawing which needs to be converted to an AutoCad drawing. I can do that but I need the thematic rules (defined in the Style Editor) to be transferred to unique AutoCad layers and the layers named according to the corrsponding Legend Label.

eg. in the Style Editor I have rules such as :

"NAME" = building

"NAME" = tree

"NAME" = road

 

So, when I run the MAPTOACAD command I want each of the above to be transferred to AutoCad layers named after the correpsonding Legend Label.

 

Any ideas?

*Expert Elite*
Alfred.NESWADBA
Posts: 9,099
Registered: ‎06-29-2007
Message 2 of 2 (152 Views)

Re: How to convert rules to AutoCAD layers

04-27-2012 01:57 AM in reply to: toolbox2

Hi,

 

one idea is you connect 3 times to the same datasource (so you have 3 different GIS-Layers).

Then you set a fitler, for layer1 filter to NAME = 'building', layer 2 filter to NAME = 'tree' and so on.

 

HTH, - alfred -

-------------------------------------------------------------------------
Alfred NESWADBA
Ingenieur Studio HOLLAUS ... www.hollaus.at
-------------------------------------------------------------------------
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.