AutoCAD Map 3D General Discussion

AutoCAD Map 3D General Discussion

Reply
Contributor
pcardinal
Posts: 13
Registered: ‎04-10-2001
Message 1 of 2 (356 Views)
Accepted Solution

Coordinate Transformation problem

356 Views, 1 Replies
12-12-2012 07:33 PM

I am using the coordinate system CANQ27-M8 in the source DWG and CANQ-M8 in the final DWG. No problem to query objects from the source DWG inside the final DWG

 

I am duplicating the NAD83 datum in the NAD83X (same parameters with a different name). I am referencing this datum (NAD83X) in a new coordinate system CANQ-M8X which is a copy of CANQ-M8 but with NAD83X instead of NAD83. Now it is impossible to query the objects from the source DWG (CANQ27-M8) in the final DWG (CANQ-M8X). Where is the problem because there is no difference between CANQ-M8 and CANQ-M8X save and except the name of the datum?

If you set up a new datum, you'll need a new transform path as well - have you defined that?  Since you are using Canadian CSs, you may need updated GSB files in that process as well.  Check out the help or http://beingcivil.typepad.com/my_weblog/2012/03/coordinate-systems-updated-mostly-canadian-version.html for some pointers.

Product Support
NateMoore
Posts: 100
Registered: ‎04-25-2008
Message 2 of 2 (315 Views)

Re: Coordinate Transformation problem

12-17-2012 02:05 AM in reply to: pcardinal

If you set up a new datum, you'll need a new transform path as well - have you defined that?  Since you are using Canadian CSs, you may need updated GSB files in that process as well.  Check out the help or http://beingcivil.typepad.com/my_weblog/2012/03/coordinate-systems-updated-mostly-canadian-version.h... for some pointers.



Nate Moore, GISP
Geospatial Premium Support Specialist
Global Services
Autodesk, Sarl
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.