AutoCAD Map 3D General Discussion

AutoCAD Map 3D General Discussion

Reply
tom
Member
tom
Posts: 4
Registered: ‎10-16-2007
Message 1 of 2 (432 Views)

Coordinate system error

432 Views, 1 Replies
08-02-2012 08:12 AM

I get an error message when I load a map with Map 2009 (XP) that was last saved by 2012 (Win7 x64).  The error message is this:

Warning: Drawing {drawing name} was created with a version of coordinate system {coordinate system name} that is different from the version installed on your system.  Coordinate conversion operations may generate incorrect results.

 

I tried opening and saving it with 2009 but the error persists.  What causes this error and what can be done about it?

 

Tom

*Expert Elite*
Alfred.NESWADBA
Posts: 9,372
Registered: ‎06-29-2007
Message 2 of 2 (397 Views)

Re: Coordinate system error

08-05-2012 01:14 PM in reply to: tom

Hi,

 

>> What causes this error and what can be done about it?

That with Map3D2012 there are a lot more coord-systems available then in 2009. And when you now open the drawing with an older Map3D version you either have not defined this coord-system or with other definition-details.

If you can verify that your 2009-version has a projection-system defined equal to that of 2012 then you should be able to assign it using the command _ADESETCRDSYS.

If you have not the same coord-system in your 2009-version you will be unable to mix data of different systems with your Map3D and this drawing.

 

- alfred -

-------------------------------------------------------------------------
Alfred NESWADBA
Ingenieur Studio HOLLAUS ... www.hollaus.at
-------------------------------------------------------------------------
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Are You Going To Be @ AU 2014? Feel free to drop by our AU topic post and share your plans, plug a class that you're teaching, or simply check out who else from the community might be in attendance. Ohh and don't forgot to stop by the Autodesk Help | Learn | Collaborate booths in the Exhibit Hall and meet our community team if you get a chance!