AutoCAD Map 3D General Discussion

AutoCAD Map 3D General Discussion

Reply
tom
Member
tom
Posts: 4
Registered: ‎10-16-2007
Message 1 of 2 (438 Views)

Coordinate system error

438 Views, 1 Replies
08-02-2012 08:12 AM

I get an error message when I load a map with Map 2009 (XP) that was last saved by 2012 (Win7 x64).  The error message is this:

Warning: Drawing {drawing name} was created with a version of coordinate system {coordinate system name} that is different from the version installed on your system.  Coordinate conversion operations may generate incorrect results.

 

I tried opening and saving it with 2009 but the error persists.  What causes this error and what can be done about it?

 

Tom

*Expert Elite*
Alfred.NESWADBA
Posts: 9,607
Registered: ‎06-29-2007
Message 2 of 2 (403 Views)

Re: Coordinate system error

08-05-2012 01:14 PM in reply to: tom

Hi,

 

>> What causes this error and what can be done about it?

That with Map3D2012 there are a lot more coord-systems available then in 2009. And when you now open the drawing with an older Map3D version you either have not defined this coord-system or with other definition-details.

If you can verify that your 2009-version has a projection-system defined equal to that of 2012 then you should be able to assign it using the command _ADESETCRDSYS.

If you have not the same coord-system in your 2009-version you will be unable to mix data of different systems with your Map3D and this drawing.

 

- alfred -

-------------------------------------------------------------------------
Alfred NESWADBA
Ingenieur Studio HOLLAUS ... www.hollaus.at
-------------------------------------------------------------------------
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.