AutoCAD Map 3D General Discussion

AutoCAD Map 3D General Discussion

Reply
New Member
dfitzwater
Posts: 2
Registered: ‎05-21-2012
Message 11 of 12 (170 Views)

Re: Connected shapefile only partially visible

05-21-2012 08:05 PM in reply to: areese9779

I am running into a similar issue with a shapefile that contains points.  Feature IDs 1-26 are plotting on the screen fine, however Feature IDs 27-49 are not showing up.  However, when I click on the item that is not showing up in the datatable, MAP3D will zoom and highlight where the point should be.  I have not set any thematic rules and my scale range is from 0 to infinity.  The shapefile opens correctly and shows all of the the data points in the trimble desktop software.  I have updated MAP3D 2012 with the latest service pack.  Hopefully someone has run into this before and can help.   Thanks. 

New Member
dfitzwater
Posts: 2
Registered: ‎05-21-2012
Message 12 of 12 (160 Views)

Re: Connected shapefile only partially visible

05-22-2012 04:12 AM in reply to: areese9779

This is an update to my issues with the shapefile not displaying all of the points.  I exported the shapefile layer data to a SDF format and now all of the points are visible.  Has anyone run into this before- can I trust a shapefile connection?

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.