AutoCAD Map 3D General Discussion

AutoCAD Map 3D General Discussion

Reply
New Member
rejeanchiragh
Posts: 2
Registered: ‎08-28-2013
Message 1 of 4 (180 Views)

AutoCAD Map 3D 2010 and Windows 2008 R2 and XenApp 6.5

180 Views, 3 Replies
08-28-2013 11:16 AM

Hi,

 

I know that installing autocad Map 3D 2010 on Windows 2008 R2 is not supported but have any of you tested on tried this configuration.

 

We need to Update our serveurs and we would prefer to install Windows 2008 R2 than and older version of Windows. We cannot upgrade AutoCAD version.

 

Could someone confirm the use of AutoCAD Map 3D 2010 (32 bit version) on windows 2008 R2 64 bit.

 

After I will try to run this configuration with XenApp 6.5.

Mentor
Robert_Fritz
Posts: 175
Registered: ‎12-08-2011
Message 2 of 4 (158 Views)

Re: AutoCAD Map 3D 2010 and Windows 2008 R2 and XenApp 6.5

08-28-2013 10:41 PM in reply to: rejeanchiragh

Hi,

 

I haven't made any tests with regards to W2008R2 but the newer versions of AutoCAD (Map) can only be installed either on 32bit or 64bit. The installer blocks installing a 32bit version on a 64bit OS. So the Map version needs to match the OS version with regards to 32/64bit structure. Not sure if that was already the case with 2010 line of products - you might find more information in Map or vanilla AC discussion lists. I think "workaorunds" have been dicussed there as well.

 

Godd luck, Rob

http://raumpatrouille3d.blogspot.ch/
New Member
rejeanchiragh
Posts: 2
Registered: ‎08-28-2013
Message 3 of 4 (140 Views)

Re: AutoCAD Map 3D 2010 and Windows 2008 R2 and XenApp 6.5

08-29-2013 05:26 AM in reply to: Robert_Fritz

Thanks Rob for your quick reply,  I'm sorry but I don't understand where is the following:

 

"you might find more information in Map or vanilla AC discussion lists. I think "workaorunds" have been dicussed there as well."

 

Where is Map or vanilla AC discussion lists.....?

 

 

Thanks again for your help.

 

Rejean

Mentor
Robert_Fritz
Posts: 175
Registered: ‎12-08-2011
Message 4 of 4 (135 Views)

Re: AutoCAD Map 3D 2010 and Windows 2008 R2 and XenApp 6.5

08-29-2013 05:32 AM in reply to: rejeanchiragh
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.