AutoCAD LT General Discussion

Reply
Valued Contributor
djboer
Posts: 91
Registered: ‎08-28-2008
Message 1 of 3 (19,637 Views)

Ungroup

19637 Views, 2 Replies
02-26-2010 02:17 AM
How do I un-group grouped items that does not want to un-group?
I've got a certain dwg file with a few groups.
I can't seem to un-group them.
Any suggestions?
*Simon Bayley
Message 2 of 3 (19,637 Views)

Re: Ungroup

02-26-2010 04:41 AM in reply to: djboer
You may need to ungroup them a few times to cancel all the groups.

Make sure all the layers are on, so that it can ungroup those too.

Check the properties of the group, it may be a block, then use explode.
*Dean Saadallah
Message 3 of 3 (19,637 Views)

Re: Ungroup

02-26-2010 04:49 AM in reply to: djboer
CTRL+SHIFT+A to toggle off grouping. Then use List to make sure they are not
blocks.

There is a group and an ungroup command in LT: abbreviate as shortcuts,
explained in Help. Or, also explained in Help, GROUP command, the pop-up,
has an ungroup option, and -GROUP command (note the dash)> Ungroup option.

--
Dean Saadallah
http://LTisACAD.blogspot.com
--
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.